Web15 dec. 2024 · Before you relight your pilot light, the first step is to turn off the gas. Locate the gas valve on your hot water heater and turn it to the “off” position. Wait approximately 10 minutes; this gives any gas in the area time to clear, which is important because the gas is highly flammable. Access the Pilot Light WebTo relight the pilot, turn the knob to the pilot position. On most hot water heaters this is a small flame or spark symbol. Once in the pilot position, press the control knob down fully …
Water heater pilot lights but burner doesn
WebStep 1: Unplug the Igniter Wire If the pilot did not light after several attempts, make sure the spark igniter is working. Unplug the igniter wire from the connector. Step 2: Reinsert the Igniter Wire Reinsert the igniter wire and make sure it is tight and secure. (This step helps remove any corrosion and ensures good electrical contact.) http://www.whirlpoolwaterheaters.com/support/help/pilot-does-not-light/42 craig hintz
How To Light The Pilot On A Modern Hot Water Heater
Web13 feb. 2024 · Lighting the Pilot Light on an Automatic Hot Water Heater For an automatic hot water heater, just repeat all steps above. But this time, do not remove any plates. All … WebPush the 3rd button (turns it all off), Then push in and hold in the first button (for pilot light) whilst pushing the 4th button several times (the spark for ignition), keep the first button pushed in for about 30 seconds. Then release the first button and push in the second button (for constant pilot flame). You may have to do this a few times. craig hinson